Page 1 of 1
Hinge Pins Doors
Posted: Sat, 12 Apr 2008, 6:13 am
by Gordon McLaren
Anybody out their had problems with door hinge pins? well i did and the solution was easy. the hinges have a countersunk headed pin , with a brass ball and spring in the middle , and a locking tab and nut on the bottom. these looked vaguely familiar , and i found their the same as Land Rover series 2a door hinge pins . e bay to the rescue and they were fitted in under 1/2 an hour. doors now very smooth , no floating up and down when opening at all.
i have a spare set if anybody wants them , cost price + carriage
cheers gordon
Posted: Wed, 18 Jun 2008, 10:13 am
by alexdundee
A spare set as in 4 of them?
I would like them please, PM me how to pay and where to send the money.
Hinge Pin Doors
Posted: Tue, 24 Jun 2008, 3:41 pm
by Grumm
Hi Guys,
Gordon, I took your lead and got some off of Ebay.
I haven't actually looked at how they dismantle and go back on......
Is it easy?
Graham
hinge pins doors fitting
Posted: Tue, 24 Jun 2008, 6:03 pm
by Gordon McLaren
very easy to remove old ones , 1- take thin bladed screwdriver or chisel , tap up folded down locktab , 2-hold pin from moving with screwdriver on top slot (scrape paint from groove first) , and with other hand use spanner or adjustable to remove nut . if nuts are rusted on use angle grinder to cut of the nut , covering fibreglass behind with thin piece of board to protect from sparks . 3- once nuts are off , the springs will fall down from the bottom part of the hinges. remove pins by lifting door upward and off , this reveals the brass ball sitting between the 2 halves.
replace the 2 new brass balls ,put door back on and drop down pins from top , spring comes over thread from bottom , compressed by lock tab and nut. tighten nuts , gently compressing springs , and adjust to suit , finish off by tapping over locktabs. you may find about 1/2 inch of thread sticking down , cut off or leave , whichever.
i replaced all four sets for both doors in approx 1/2 hour. it makes a big difference , their is no floating up and down and i find the doors shut considerably better.
cheers gordon
Hinge Pins Doors
Posted: Tue, 24 Jun 2008, 6:31 pm
by Grumm
Gordon
You make it sound very easy! I will give it a go..........
At the moment, both halves of the door catch each oher and a previous owner has not been too careful, causing a bit of damage.
Hopefully, this will help to keep the two halves "apart"
Cheers
Graham
Posted: Wed, 25 Jun 2008, 11:27 am
by alexdundee
Thanks Gordon, I'll have a go this weekend.
Alex.
Re: Hinge Pins Doors
Posted: Sat, 10 Dec 2016, 11:41 pm
by Admin
I now keep these hinge pin kits in stock, and I'm cheaper than anyone online or on eBay!
http://portafold.co.uk/parts_and_spares ... n_kit.html
Email me to place your order.